Initial Setup
- Open Meet Manager and go to Run
- Select Interfaces > Setup > Photo Finish
- Select FinishLnyx Serial Interface and click OK
- Select Interfaces > Photo Finish - FinishLynx Serial Mode > Open/Close Serial Port
- In Photo Finish (0-16): field enter correct Port Number and click OK
- Note: See Open the Correct Port (Timing Console Interface) to select correct Port Number
- Update Start Lists menu will appear. Select correct Session and click OK
- Select Interfaces > Photo Finish - FinishLynx Serial Mode > Set Baud Rate
- Select Baud Rate and click OK
- Note: Ensure Meet Manager Baud Rate matches the Baud Rate on FinishLynx Console. Default in Meet Manager is 9600
Importing Results from FinishLynx into Meet Manager
- Open Meet Manager and go to Run
- Select event and heat
- Click Get Times: F3 to import results
